A dark modern bedroom with grey bedding, a wall-mounted air conditioning unit, and a cat resting on the bed.

Mini Split Installation in Clermont, FL

A new system here will heat from December through February and cool from March through November every year. Tell us about the house, and a licensed contractor who covers Lake County will get in touch.

Tell us about the job

It takes about a minute.

Step 1 of 3: Equipment
A modern bedroom with dark furnishings, a wall-mounted air conditioning unit, and a cat resting on a large bed.

In Clermont, a mini-split works nearly all year

Cooling runs March through November here, nine months of the year, with summer afternoons averaging 91°F. Winter only asks for heat from December through February, and even then nights average 49°F. That leaves almost no month where the system just sits idle.

A new unit installed here has to be sized for that long cooling stretch first, since that is what it will run most. Any mini-split manufactured from 2023 onward has to meet 14.3 SEER2 for cooling and 7.5 HSPF2 for heating, so that baseline is set regardless of who installs it. Florida also sees its share of storms, and outdoor units need to be mounted and wired in a way that holds up through wind.

3 months
December through February, your system heats
9 months
March through November, it cools
49°F
the average winter night it heats against
91°F
the average summer afternoon it cools against
Isometric cutaway illustration of a small house with a dark shingled roof, showing two wall-mounted indoor air conditioning units in separate rooms connected by lines to an outdoor condenser unit on the ground outside.
Your system heats December through February and cools March through November.

NOAA nClimDiv, 1991–2020 normals

Florida requires HVAC contractors to hold a state license.

That license comes from the state's Construction Industry Licensing Board, which tests contractors before they can hold one. It covers the contractor, not the job itself, so the same license follows them from one installation to the next rather than being issued fresh for this one.

For a mini-split, that license tells you the contractor who sold you the work was tested and is on record with the state. In most cities and counties, installing one still needs a permit from the local building office and an inspection once the work is done, which gives the wiring and the mounting a second set of eyes beyond the contractor's own.

Sources: Florida Legislature · Florida Department of Business and Professional Regulation

Is a mini split worth it?
For most homes here, yes. Clermont needs cooling nine months a year and heat the other three, so a system that does both from one unit stays useful year round. A mini split also cools or heats just the room or zone it serves, so you are not running a whole system for one occupied room. If your home already has working ductwork and a central system, a mini split makes more sense as a fix for one hot or cold room than as a full replacement.
How many rooms can a mini split cover?
A single indoor unit covers one room or open area. If you need more rooms covered, a multi-zone system lets one outdoor unit run several indoor units, each with its own thermostat, so a bedroom and a living room can be set differently at the same time. How many zones one outdoor unit can support depends on the equipment, so a contractor will size it to the rooms you want covered.
Can a mini split heat a whole house?
It can, if the system is sized and placed for the whole house rather than one room. A multi-zone mini split with an indoor unit in each main area can carry the heating load down to Clermont's winter lows, which average 49°F. Whether that makes more sense than a central system depends on the layout of the house, so a contractor will need to look at the home to size it right.