Heat Pump Repair in Naples, FL
If your system quits, tell us what it's doing and a licensed contractor who covers Collier County will get in touch.
Tell us about the job
It takes about a minute.
Your heat pump runs every month, all year
In Naples, there's no season off. The heat pump cools through summer afternoons that average 92°F, then switches over to heat on winter nights averaging 56°F. It never gets a real rest.
That kind of year-round run time wears on the compressor and the reversing valve, the part that switches the system between heating and cooling. When the reversing valve starts to stick, you'll notice the system blowing warm air when it should be cooling, or the outdoor unit running but the house not responding. With most homes here heating with electricity, a heat pump that's struggling means the whole house feels it.
- 56°F
- the average winter night it heats against
- 92°F
- the average summer afternoon it cools against
Florida requires HVAC contractors to hold a state license.
The Construction Industry Licensing Board tests contractors before they're allowed to hold that license, and it keeps a record of who holds one. The license belongs to the contractor, not to any single job, so the same license that covers a heat pump repair covers the next job they take on.
A heat pump repair often means opening the refrigerant side of the system, whether that's checking the charge or fixing a leak. Any technician who does that, in Florida or anywhere else, has to hold EPA Section 608 certification. That's a federal requirement separate from the state license, and it applies no matter where the job is.
Sources: Florida Legislature · Florida Department of Business and Professional Regulation
- Why is my heat pump blowing cold air?
- In cooling mode, a heat pump is supposed to blow cold air, so that alone is not a problem. If the air isn't as cold as it should be, check the thermostat setting first and make sure the filter isn't clogged. A dirty filter cuts down airflow across the indoor coil, and that shows up as weaker cooling at the vents. If the filter is clean and the air still isn't cold enough, or the system is running nonstop without keeping up, a contractor should check the refrigerant charge.
- Why is there ice on my heat pump?
- Ice on the outdoor unit usually means airflow across the coil is restricted. A dirty filter, blocked return vents, or debris and leaves packed against the outdoor coil can all cause this, since less air moving over the coil lets it get cold enough to freeze. Low refrigerant does the same thing, cooling the coil below what the airflow can keep up with. Turn the system off and let the ice melt rather than chipping at it, then have a contractor find out why it iced up before running it again.
- Why is my heat pump running but not cooling?
- This usually points to either a refrigerant problem or something blocking airflow. Start with the filter. If it's clogged, not enough air is moving across the indoor coil to pick up cold and carry it through the house. Check that the outdoor unit isn't crowded by plants or debris, since it needs open air around it to release heat. If the filter is clean and the outdoor unit has clear space but the air coming from the vents still isn't cold, the system likely has a refrigerant leak or a failing part, and a licensed contractor will need to diagnose it.